Try Our New Website. Click Here * Under Construction *
Note: All orders with merchandise totaling less than $50.00 are charged a Minimum Order Fee of $10.00. It will automatically added to your S&H. Buy more, save more!
4" Remodel LED Housing
Litonia L3RLED T4 4" Remodel LED Housing
FEATURES & SPECIFICATIONS
INTENDED USE � Recessed housing rated IC or Non-IC. For remodel construction only.
Approved for factory assembled wiring only.
Approved for direct burial in insulation.
CONSTRUCTION � Air-tight standard. Tested to meet current energy codes.
Aluminum foam-gasketed housing with three remodel clips for installation in existing plaster, sheet rock or mechanical ceiling.
Heavy-gauge galvanized steel raceway arm.
Galvanized steel junction box with four built-in Romex clamps. Five 1/2" knockouts with slots for pryout.
Not suitable for pulling wires.
Rated for 90� C.
Ground wire provided.
Removable J-box doors for easy access.
ELECTRICAL � Quick disconnect provided for power connection to the LED modules.
Paint overspray masked by disposable disconnect plug.
Housing and LED module combination is IC rated and thermally protected.
120 volt only.
INSTALLATION � Air-tight housing suitable for air-tight installations. Refer to energy codes for proper
installations.
2x8 and 2x6 existing ceiling or T-bar ceiling panel installation. Clip adjustment on housing (up to 1/2") allows for flush mounting with ceiling face.
LISTINGS � UL Listed to US and Canadian safety standards. Damp location listing (See trim selection
for wet location listing).
WARRANTY � 1-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Note: Actual performance may differ as a result of end-user environment and application.
Specifications subject to change without notice.
Specifications
Height: 5-1/2 (14.0)
Length: 10-1/8 (25.7)
Width: 5-3/4 (14.6)
Ceiling opening: 4-1/4 (10.8)
Ceiling cutout template: 4.01
All dimensions are inches (centimeters) unless otherwise specified
