Try Our New Website. Click Here * Under Construction *
Note: All orders with merchandise totaling less than $50.00 are charged a Minimum Order Fee of $10.00. It will automatically added to your S&H. Buy more, save more!
6" Remodel LED Housing
Litonia L7XRLED T24 R6 6" Remodel LED Housing
FEATURES & SPECIFICATIONS
INTENDED USE
Recessed housing rated IC or Non-IC. For remodel construction only.
Approved for factory assembled wiring only.
Approved for direct burial in insulation.
CONSTRUCTION
Air-tight standard. Tested to meet current energy codes.
Aluminum foam-gasketed housing with three remodel clips for installation in existing plaster, sheet rock
or mechanical ceilings.
Heavy-gauge galvanized steel raceway arm.
Galvanized steel junction box with four built-in romex clamps, five 1/2" knockouts with slots for pryout.
Not suitable for pulling wires.
Maximum 4 (2 in, 2 out) No. 12 AWG conductors. Rated for 90� C.
Ground wire provided.
Removable J-box door for easy access.
Trim retention (TOR): Two-side mounted torsion springs on the trim and 2 receiving brackets in the can
ensure a consistently tight fit with the ceiling.
ELECTRICAL
Quick disconnect provided for connection to LED modules.
Paint overspray masked by disposable disconnect plug.
Housing and LED module combination is IC rated and thermally protected.
120 volts only.
INSTALLATION
Air-tight housing suitable for air-tight installations. Refer to energy codes for proper installations.
2 x 8 existing ceiling or T-bar ceiling panel installation.
Clip adjustment on housing (up to 1-1/4�) allows for flush mounting with ceiling face.
LISTINGS
UL Listed to US and Canadian safety standards. Damp location listing (See trim selection for wet location
listing).
WARRANTY � 1-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 �C.
Specifications subject to change without notice.
Specifications
Height: 7-1/2 (19.1)
Length: 12-1/4 (31.1)
Width: 5-3/4 (14.6)
Ceiling opening: 6-7/8 (17.5)
Ceiling cutout template: 6.65
All dimensions are inches (centimeters) unless otherwise specified.
